Return to Center

Release: >0.906

Description

This function instructs WebControl to send a command to the controller to return the sled to center of the work area.

Process

WebControl places the controller in absolute position mode by sending:

G90

WebControl instructs the controller to raise the Z-axis to the ‘safe height’ (Maslow Settings -> Z-Axis Safe Travel Height in MM)

G00 Zxx

where xx is the value for the safe height.

Maslow instructs the controller to move to the center of the work area (i.e., 0,0)

G00 X0.0, Y0.0

Troubleshooting